Silk Screen Fabric Printing Directions
- Cut out a stencil on wax paper
- Stencil should be be no bigger than the squeegee
- try not to have big open shapes (the bigger the shape the more ink will be required)
- if you rip your stencil, you can repair it by taping the non-shiny side of the paper together
- Run tape along the edges of the inner frame and screen of the silk screen
- Place masonite under the part of the fabric you want to print on
- Make sure you are using the smooth side of the masonite (one side is for cutting and one side is for printing)
- Place the paper shiny side up on the fabric
- Place the frame screen side down on top of the paper
- Add a generous amount of ink to the bottom of the screen
- Flood the screen by lightly pushing the ink upward with the squeegee
- Have the squeegee at an angle and press down, pushing the ink back to the bottom of the screen
- The thicker the fabric the more ink and passes with the squeegee are required
- When you are done with a print remove the screen and the stencil
- Scrape the excess ink back into the ink container
- Throw away the stencil and clean the rim of the ink container with a damp paper towel before closing it again
- Take the tape off of the silk screen
- Wash the silk screen as soon as you can, after you are done printing
- A spray bottle of watered down dish soap and brush are at the sink
- Let the silk screen dry on the cart after washing and let your print dry for around 30min
- With this ink, if you want to wash your garment after, it is recommended to wash cold and let it air dry
No comments:
Post a Comment